The temperature is increasing. The sun is shining brightly. Right now, a swim in the pool sounds like a nice idea.

But hold off on jumping in just yet! If the swimming pool has been closed for the winter, you’ll need to conduct some preparation work before opening it for another season of pleasure. But don’t be concerned. It is simple to open an inground/above-ground pool or do a fiberglass pool installation process. Following are the few simple steps that will have you perfecting your cannonball in no time!

Clean Up Any Debris And Inspect For Signs Of Wear And Tear.

Take some time to study your pool’s environment before you open it. Trees and hedges that have grown out of control should be pruned. Remove any neighboring leaves with a sweeping motion. Before fiberglass pool installation or opening of the pool for the season, inspect it for damage, wear or tear, and make any necessary repairs. Make careful to clean and repair any deck furniture before using it. Check the pool’s safety rails, slides, rescue apparatus, ladders, and diving boards, among other things.

Make A List Of The Chemicals In Your Pool.

Before you start opening your pool or book any fiberglass pool dealers, ensure you have all of the required chemicals.

Here’s everything you’ll need to complete the task properly:

• A decent test kit or test strips for evaluating the chemistry of your pool’s water
• Chlorine is used to sanitize surfaces daily.
• Shock therapy
• Chemicals for appropriately correcting the water balance in your pool
• Treatment with algaecide
• Filter cleaners and other problem-prevention items are required.

Take Off The Pool Cover

The swimming pool cover collects water and debris during the fall and winter months. First, remove the old, unclean water using a pool cover pump and keep it out of your pool. After removing the cover, hose it down and thoroughly clean it before allowing it to dry.

Examine The Fiberglass Pool

Give your pool a thorough inspection before it opens. In addition, you must include the following things on your to-do list:

• Drain plugs or winterizing plugs should be removed from surface skimmers and wall returns, and directed fittings should be restored.
• Examine the filter and pump for any broken or worn parts and repair them as needed.
• If you took off the underwater pool lights, now is the time to put them back on.
• Examine your pool’s finish and decking for any damage or signs of wear and tear.
• Examine your tile and use a swimming pool scale removal solution to eliminate calcium buildup and discoloration. For the finest items to use, please consult your local pool specialist.

Inspect the pool’s interior for damage and make any repairs.

Fill The Pool To The Center Of The Waterline Tile And Clean Up The Debris.

Finally, fill the pool with a garden hose until it reaches the midway of the waterline tile or the center of the skimmer aperture. Once the water level is needed, use a pool brush to clear leaves, twigs, and debris from the pool’s bottom. Make sure the basket is clear of any debris.

Test The Water After Turning On The Pool Filter.

You’ve almost made it! Now you just need to put on the filter and operate it. Before testing or adding chemicals, please turn on the filter and let it run for 12 to 24 hours to circulate the water.

Professional water testing is essential when you first open your pool and again once a month throughout the season. A water sample may always be taken to a pool specialist for accurate analysis. In addition, your pool specialist will provide you with guidance on balancing the water in your pool.

They may check the pH, alkalinity, calcium hardness, and chlorine levels in the water. Now you may need to add a stabilizer, phosphate remover, metal treatment product, or algaecide to your pool before it’s suitable for the warm season and shocking it.

Keep the filter running for a few days, sweeping away any accumulated dirt. Then, your pool is suitable for swimming after the water is clean and the chlorine levels have decreased.